Voltage to Current Converter using Op Amp

Hi friends, in this post we will see how to convert voltage into current using simple circuitry. In most of the cases we get the output of measuring devices in the form of voltage. It is not good to transmit this output voltage to the destination directly. Due to addition of noise and wire impedance the output voltage may get corrupted. So in such cases we have convert that voltage into current form. So let us see voltage to current converter.

Voltage to Current Converter using Op Amp

Following circuit shows the voltage to current converter using operational amplifier. It consist of simple resistance connected to the inverting and non inverting terminals of op amp.

Voltage to Current Converter
Voltage to Current Converter

In this circuit the load is grounded and the current through the load can be calculated as follows.

The current through the load is given by,

The gain of the amplifier is

So

Substituting this value in above equation we get,

Thus the current is directly proportional to the applied voltage and the resistance used in the circuit. it should be noted that all the resistances used in the circuit are equal to R.

See alos: Current to Voltage Converter

If you like this article, please share it with your friends and like or facebook page for future updates. Subscribe to our newsletter to get notifications about our updates via email. If you have any queries, feel free to ask in the comments section below. Have a nice day!

2 thoughts on “Voltage to Current Converter using Op Amp”

Leave a Reply